Top
Proshop
Sponsors
News:
Fly the Team Iceshanty Flag!
Iceshanty Proshop
Home
Forum
Help
Login
Register
IceShanty.com's Ice Fishing Community
»
New York
»
Ice Fishing New York
(Moderators:
LoneWolf
,
ChenBassHead
,
Pasquatch
,
cold_feet
,
Bussman
,
adkRoy
,
prchslyr
,
Raquettedacker
) »
welded on ripper blade (how to sharpen)
New York Ice Fishing sponsored by
Print
Pages: [
1
] |
Go Down
Author
Topic: welded on ripper blade (how to sharpen) (Read 315 times)
aj454
Team IceShanty Addict
Posts: 841
welded on ripper blade (how to sharpen)
«
on:
Jan 28, 2013, 11:04 AM »
I have an old jiffy with welded on ripper blade. I put it in the vise standing straight up and down. I then took a file and gently filed downward toward the floor. This seemed to work seeing it would not cut one hole. Now it cuts but was wondering if anyone has any suggestions such as using a stone on it or something else to get a sharper edge?? Thanks
Logged
joefish
Team IceShanty Regular
Posts: 331
Re: welded on ripper blade (how to sharpen)
«
Reply #1 on:
Jan 29, 2013, 05:54 AM »
Did you sharpen the edges of the point also. Make sure you use a very fine file and keep the angle the same. Have been doing it for years and it cuts better than the new ones.
Logged
mealworm
Team IceShanty Maniac
Posts: 4,057
summer sucks
Re: welded on ripper blade (how to sharpen)
«
Reply #2 on:
Jan 29, 2013, 06:00 AM »
i have used a fine sandpaper to help razor sharpen blades,don't see why it wouldn't work on an auger blade,getting the right angle to the dangle is the key though
Logged
https://s26.postimg.cc/gv4w7bzvd/smallred.jpg
Print
Pages: [
1
] |
Go Up
IceShanty.com's Ice Fishing Community
»
New York
»
Ice Fishing New York
(Moderators:
LoneWolf
,
ChenBassHead
,
Pasquatch
,
cold_feet
,
Bussman
,
adkRoy
,
prchslyr
,
Raquettedacker
) »
welded on ripper blade (how to sharpen)
Iceshanty
|
MyFishFinder
|
MyHuntingForum
Contact
|
Disclaimer
|
Privacypolicy
|
Sponsor
© 1996- Iceshanty.com
All Rights Reserved.