? for fellow x67 owners

[chucknduck]

So the last two times I've had it out there is a lot of surface clutter down to 4 or 5 ft. I tried the low med and high surface clutter settings. The high setting removes the clutter but it will not pick up my jig in that zone. It's not. Prob when fishing for perch bit when I'm fishing 10 fow for trout that is almost half of the water column that is screwed up.

Has anyone else had this problem? If so how do you fix it?

[tiptoe]

Haven't had this problem. Just checked my settings...surface clarity is set to High and is in "ice machine mode".  I assume that you are adjusting the sensitivity throughout the day?

[chucknduck]

Yea I always adjust sensitivity.  Like I said when I turn surface clarity up I seem to loose my jig. But when its off there is so much clutter I can't see my jig.  Yesterday it was showing a solid yellow red line at 2 ft like you see when you have a solid bottom.