The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service
Pages: [1] |   Go Down

Author Topic: Will the flyte fit?  (Read 759 times)

Offline big-brother

  • Team IceShanty Maniac
  • **
  • Posts: 1,028
  • bring on the ice!
Will the flyte fit?
« on: Nov 01, 2009, 07:41 PM »
Are the 8" and 10" flytes interchangeable on the older 3HP Jiffy 30 augers?Have the chance to purchase an 8" flyte and downsize from the 10" i have now.
Logged

Offline Nor Easter

  • Team IceShanty Maniac
  • **
  • Posts: 2,035
  • Just an old coot takin a Li'l Crappie on the ice
Re: Will the flyte fit?
« Reply #1 on: Nov 02, 2009, 01:37 PM »
Make sure the new auger runs the same way as your J30 which should be CCW.

Are you looking at new or used?

If used, be careful as the old 8 inch Jiffy`s used a one piece auger and blade. Non-replaceable. You can only resharpen it.
Logged
Caveat Emptor et cum grano salis
I enjoy helping people out,,, which way did you come in?
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.