The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service
Pages: [1] |   Go Down

Author Topic: Auger "Cone Hole" maker?  (Read 2118 times)

Offline HUNTER16

  • IceShanty Rookie
  • **
  • Posts: 94
Auger "Cone Hole" maker?
« on: Mar 12, 2007, 05:43 PM »
I haven't seen this for a few years now.  But does anyone remember an attachment (used on a power auger) to make the bottom of your hole cone shaped.  After it was used the hole looked like an upside down funnel.  Did anyone ever own one of these?  How did it work, and are they still made?
Logged
Happiest when on a frozen lake!

Offline LoneWolf

  • Tournaments/Mod Team
  • Team IceShanty Maniac
  • *
  • Posts: 4,182
  • Hardwater Fanatic! >))))>
Re: Auger "Cone Hole" maker?
« Reply #1 on: Mar 12, 2007, 06:14 PM »

You can check here .. Augers

There was the same question asked about a month ago. If I remember correctly there was a problem with the unit locking under the ice and you couldn't get your auger out.

Logged
Those who are brave are free ..

Offline fiddlehead322

  • Team IceShanty Maniac
  • **
  • Posts: 1,232
  • Night time is the right time!
Re: Auger "Cone Hole" maker?
« Reply #2 on: Mar 12, 2007, 07:13 PM »
Cone hole?  I hear banjos. ???
Logged
Looking forward to some "crappie" nights!

Offline bridgedoctor

  • Team IceShanty Regular
  • ***
  • Posts: 136
Re: Auger "Cone Hole" maker?
« Reply #3 on: Mar 12, 2007, 07:50 PM »
You're looking for the "Ice Angler".  It's a cutting device that attaches to a gas auger drill and automatically enlarges the base of your hole into a conical shape as you pull up on the auger.  The wide-based hole is make it easier to slip a large fish into the hole.
Logged
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.