Support Iceshanty... Get some great gear and forum goodies... Join The Iceshanty Hardwater Militia
Pretty sure it's a matter of clearance between the point and the inside corners of the blades. Probably gonna have to do some grinding and that isn't going to happen until the temps are a little better for hanging out in the garage. I didn't notice at first but I didn't get the same points that Lefty got and that they show in their advertising. These have a flange on them so they can't be screwed in as far.On the plus side the tapping operation went fine. The hole that was there was the right size, just cleaned out the powder coat a bit and cranked in the tap.
I cant really see what the flange is, is it a teflon type washer molded onto it? Looks white in your picture
can you guys tell the difference with n without?
It's alive. I ground off the flange and managed to get it far enough down in there and it cuts again now. I only drilled one hole to test quick, but I'll play around with it some more when I have time. Depending on how that goes I might leave it like it is, or grind the sides down a bit so I can move it out past the blades a bit farther.