new nils help

[ICE KID]

took the nils out today and it worked great, until dad used it , then we couldn't get through 4 inches of the hard stuff, he said he didn't put a lot of pressure on it, I think he either bent the blades or the auger shaft it's self, cuz it seems like it will cut through The first inch great, but after that it wants to go around the hole and even then it just kind of spins without cutting, any ideas what the problem may be and or how to fix it, he's thinking about returning it and I don't Want him to 

[fin-n-feather]

From everything I've read on this site about the Nils cutting head is you have to be careful with it. It sounds like you said, that the blades got damaged or bent. Your only solution might be is to get a new cutting head. Fin

[evobassfish]

ouch, doesn't sound to good. i was using my 8" today with at least 8" of ice with no problems. with the nils there should be little to no pressure at all to cut through the ice. hate to say it but you might need to get a new cutting head, if you do at least you will have a spare that you can get resharpened.

[olgreenhead]

where do get them resharpend?

[esox_magnum]

Nils Master Authorized Sharpening Service.

Nils blades are inspected and adjusted back to factory standards as needed.
On to the sharpening for a hair splitting edge put on the blade.
For Quality Control all blades are tested.

All this for $20 plus return shipping.
Include cash/check plus shipping cost with your blade along with
return address and email address or phone number.

My goal is to get you your blade back to you ASAP!
Many times blades are shipped the same day are received.

Ship to:

Frank DeLuca
5382 Jentoft Rd
Saginaw, MN
55779

Contact Frank by email:

[email protected]

[Double-L]

 Thinking of maybe getting one of those? (Reason I jumped in)......LL

[olgreenhead]

well i found a place werei can buy a new head for 44$ now ill have 3 heads

[davek134]

Where you find a new for 44?