I use a 7.5 inch K-drill and Milwaukee M18 drill. At the end of a day of fishing, I cannot remove the k-drill from the chuck without using a strap wrench. I tighten the chuck simply by holding the chuck in my hand and running the drill in forward. When I try to reverse the process (and run the drill in reverse) at the end of the day, the chuck will not loosen and release the drill. I break out the rubber strap wrench and with some elbow grease, I can get it to release, but it is not easy. Anyone else have a similar problem? I've read somewere that some early M18 drills had bad chucks and I wonder if mine falls into that category.
Thanks for any input or advice.
Dan