The Dark House Spearing board is sponsored by:
Pages: [1] |   Go Down

Author Topic: Hole ?  (Read 841 times)

Offline Captain Happy

  • IceShanty Rookie
  • **
  • Posts: 66
Hole ?
« on: Jan 28, 2014, 10:47 AM »
Using a power auger, can you overlap the holes?  Wondering if the auger would spin away from the first hole drilled?   Or do you have to get 2 holes close to each other and spud it out.  Thanks the Captain
Logged

Offline MJ1657

  • IceShanty Rookie
  • **
  • Posts: 77
Re: Hole ?
« Reply #1 on: Jan 28, 2014, 06:37 PM »
If you're careful you can overlap them. It tends to get a little messy as you start pumping quite a bit of water to the surface.
Logged
Know before you throw

Offline delfisher

  • Team IceShanty Regular
  • ***
  • Posts: 198
  • Catch and release 247
Re: Hole ?
« Reply #2 on: Jan 28, 2014, 06:45 PM »
Read the Laws in your states  fish commission booklet , The law in Pa. is 10 inches, either diagonal if square or diameter if round is the largest hole you can make and I believe its for safety reasons
Logged
There's nothing better in life then being outside on a cold winter day hanging around with a bunch of icehole's

Offline StabinCabin

  • Team IceShanty Addict
  • *
  • Posts: 807
Re: Hole ?
« Reply #3 on: Jan 29, 2014, 05:24 AM »
Most of the time i cut a 3x4 hole.
Logged
Rippin lips one at a time.
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.