Ice Fishing Iceshanty Tips board is sponsored by
Polar Bird Ice Shelters

Author Topic: ....... Fish Trap Tips ........  (Read 130736 times)

LoneWolf

  • Tournaments/Mod Team
  • Team IceShanty Maniac
  • *
  • Posts: 4,027
  • Hardwater Fanatic! >))))>
....... Fish Trap Tips ........
« on: Jan 11, 2007, 05:21 PM »
Someone had removed my original thread (from Oct 27, 2004) full of usefull info so I'll start over again.

Click here for Old FT Tips Board


Last season I recieved a few PM's asking advise on rigging the Fish Traps. Yesterday I recieved an e-mail with a few questions so I figured I would start a post with some tips and hopefully others will add to it. ;D

1)Instead of tying the pull rope thru the holes I added SS eye bolts and SS fender washers.
2)On the rear I did the same (SS eye bolts, fender washers) for a tie down point for my anchors on windy days. I use brass snap connectors tied to the end of the anchor ropes for a quick connect/disconnect.

Yesterdays questions were regarding the transport of an auger on the Fish Trap. Years ago I learned the hard way how much oil drips out the exhaust and stains the tent. I came up with two solutions which work when combined. The first was to switch to Opti 2 oil. Reduced the smoke, less oil dripping from the exhaust and revs higher. The second was to get a gym bag with two zippers that just fit over the power head. I slip the bag over the power head and pull the zippers and the dripping is contained. At the end of each season I wash it and I'm good to go next season. One extra tip is to keep the blade cover on the auger when transporting. Here are a few pic's :



Those who are brave are free ..

LoneWolf

  • Tournaments/Mod Team
  • Team IceShanty Maniac
  • *
  • Posts: 4,027
  • Hardwater Fanatic! >))))>
Re: ....... Fish Trap Tips ........
« Reply #1 on: Jan 11, 2007, 05:36 PM »

It's hard recreating all the tips but here's another for rod holders.

I wanted a rod holder to keep the rod within easy reach and easily detachable. The one I found and liked the best was Outdoor Creations Hot Rod Holder. Here's some pics :


Mounted with rods.


Close up of holder.
Those who are brave are free ..

Arse

  • IceShanty Rookie
  • **
  • Posts: 4
Re: ....... Fish Trap Tips ........
« Reply #2 on: Jan 12, 2007, 02:17 PM »
Lonewolf, I'm new here and I found your tips to be very helpful, then they disappeared. I finally found them in the archives at http://www.iceshanty.com/archives/forum2/index.php?topic=14164.0

Mike

LoneWolf

  • Tournaments/Mod Team
  • Team IceShanty Maniac
  • *
  • Posts: 4,027
  • Hardwater Fanatic! >))))>
Re: ....... Fish Trap Tips ........
« Reply #3 on: Jan 14, 2007, 10:16 AM »

They weren't even there a week ago. IceShanty retrieved them and restored them to the archives.
I had recieved many PM's asking where the thread was as members wanted use the many tips from other members, mods and myself.
I'm still looking into who had removed it.



Those who are brave are free ..

BUSCHLITE

  • Team IceShanty Regular
  • ***
  • Posts: 178
Re: ....... Fish Trap Tips ........
« Reply #4 on: Jan 16, 2007, 04:27 PM »
Thanks for getting this thread back on top. I just bought a Scout and the tips will be gratefully appreciated. ;D ;D ;D

jepik

  • Team IceShanty Regular
  • ***
  • Posts: 275
Re: ....... Fish Trap Tips ........
« Reply #5 on: Jan 17, 2007, 09:27 AM »
what lub. to use on tent poles?..I have tried taking poles apart and  sanding inside edge...everything from wd 40 to car wax...they all help...did anybody find something new to try? ;) ;)

LoneWolf

  • Tournaments/Mod Team
  • Team IceShanty Maniac
  • *
  • Posts: 4,027
  • Hardwater Fanatic! >))))>
Re: ....... Fish Trap Tips ........
« Reply #6 on: Jan 17, 2007, 05:06 PM »

I've found car wax to work the best. Over the years I've tried silicone, WD-40, etc. but the car wax is quick, clean and simple. Also you don't stain the tent with the car wax like you can with the spray on products ... they can drip out on the tent.

 
Those who are brave are free ..

feasanthunter

  • Team IceShanty Regular
  • ***
  • Posts: 161
Re: ....... Fish Trap Tips ........
« Reply #7 on: Jan 17, 2007, 05:44 PM »
I bought a guide last month, used car wax on the poles and it was a big improvement . I also waxed the slides for the seats. New shanty, new Vex, no ice :(
are you gonna pull those pistols, or whistle "Dixie"?

empty hook

  • Team IceShanty Addict
  • *
  • Posts: 563
Re: ....... Fish Trap Tips ........
« Reply #8 on: Jan 17, 2007, 05:55 PM »
I've found car wax to work the best. Over the years I've tried silicone, WD-40, etc. but the car wax is quick, clean and simple. Also you don't stain the tent with the car wax like you can with the spray on products ... they can drip out on the tent.

 
I also use car wax.  I put a thin layer on and don't remove the film seems to last longer.

toy4runner4x4

  • IceShanty Rookie
  • **
  • Posts: 19
Re: ....... Fish Trap Tips ........
« Reply #9 on: Jan 22, 2007, 09:59 AM »
I just got an aqua-vu scout and wanted to know if anyone has theirs mounted to their fish trap? Pics would be great. Thanks.

jepik

  • Team IceShanty Regular
  • ***
  • Posts: 275
Re: ....... Fish Trap Tips ........
« Reply #10 on: Jan 30, 2007, 12:04 PM »
does anybody know how to get past page 4.... 1-27 05...in the fish trap tips..would like to find all the missing info. from 1-27--05 to present... ???

NJ PIKER

  • Team IceShanty Addict
  • *
  • Posts: 681
  • Huntin 4 Forties
Re: ....... Fish Trap Tips ........
« Reply #11 on: Jan 30, 2007, 05:14 PM »
otter makes a nice rod holder also
all you need to do is drill 2 holes[all hardware included]
got mine at Cabelas for $ 12 :tipup:
 http://eelement.appolis.com/OTTEROUTDOORS/eproddetail.asp?S=67&P=5050&PubID=4393&V=7&PID=1064&iss=


   

Big BAIT :tipup: Big ESOX                                                                   <><      }*)))))))))))))))))))><{

Dave C

  • IceShanty Rookie
  • **
  • Posts: 8
Re: ....... Fish Trap Tips ........
« Reply #12 on: Feb 11, 2007, 08:35 PM »
Want to let everyone know that my idea of using medium size binder clips (rather than the supplied screws) to hold the tent onto the sled has worked great. No slippage in the tent from wind or use. I have loaded the tent into my pickup many times this winter and the binder clips have held fast. Also, no rust so far. So, this spring I will pop the clips off, take the tent off and store inside and store the tent in my shed. No mouse prroblems eating holes in the fabric. If anyone else has tried it, let me know how they worked for you.

jepik

  • Team IceShanty Regular
  • ***
  • Posts: 275
Re: ....... Fish Trap Tips ........
« Reply #13 on: Feb 15, 2007, 05:55 PM »
do you put the cover on when pulling behind a quad or snowmobile every time you move...I read and I believe it was in this thread what is the best way to put the cover on...with all the clothes on and being 67 it begins to be pain...thinking about mud flaps on the back of the quad....any help would be appr. thanks... ;) ;)

gldnrcher

  • IceShanty Rookie
  • **
  • Posts: 3
Re: ....... Fish Trap Tips ........
« Reply #14 on: Feb 17, 2007, 01:17 PM »
It's hard recreating all the tips but here's another for rod holders.

I wanted a rod holder to keep the rod within easy reach and easily detachable. The one I found and liked the best was Outdoor Creations Hot Rod Holder. Here's some pics :


Mounted with rods.


Close up of holder.
hello lonewolf I think these are your pics the rod holders look great where did you find them I looked at the usual places but no luck I'm gonna try to search the manu.

LoneWolf

  • Tournaments/Mod Team
  • Team IceShanty Maniac
  • *
  • Posts: 4,027
  • Hardwater Fanatic! >))))>
Re: ....... Fish Trap Tips ........
« Reply #15 on: Feb 17, 2007, 02:39 PM »
hello lonewolf I think these are your pics the rod holders look great where did you find them I looked at the usual places but no luck I'm gonna try to search the manu.

I believe Thorne Bros still carry them.  :)
Those who are brave are free ..

Wolf Point

  • IceShanty Rookie
  • **
  • Posts: 19
  • Wolf Point Lodge, Crane Lake, MN
Re: ....... Fish Trap Tips ........
« Reply #16 on: Mar 01, 2007, 09:31 AM »
As a new owner of a Fish Trap X2, I was interested in the preferred way to setup and take down the trap. I e-mailed Clam, and the engineers replied with the following recommended procedure:

Set-Up


1) From outside the shelter, standing on the side that will be the rear wall when erected, start with the  lowest hoop in the stack and work upwards, pulling on each hoop from outside the tent and until you feel the buttons engage.
 
2) From either side/end of the shelter, flip them all forward.

3) Go inside and install the Roof Spreaders, then the Front Spreaders, and finally the Rear Spreader/s (Spreader count varies with shelter style/configuration – smaller shelters use only a Rear Spreader).


Take-Down

 

1) Remove all Spreaders and lay in the bottom of Base. For Adjustable Spreaders, snug the Tension Knobs after compacting so that they don’t vibrate out during transit.
 
2) Start with the rear wall Hoop and compress both buttons and retract the Hoop, then the same with next inward Hoop, and then the third inward Hoop.
 
3) Step out and swing the Porch Hoop on the previously retracted Hoops while at the same time disengaging buttons and retracting.
 
4) Go around the shelter and tuck the Tent material in between the rested Hoops the best you can to keep the Tent material from dragging during transit – a Travel Cover works great here to hold everything together.
Note: Make sure that the Tent material is clear of the Canopy Brackets to minimize rubbing.

Wolf Point


bladebait

  • Team IceShanty Regular
  • ***
  • Posts: 266
  • Keep Your Line Wet And Your Noodles Warm!
Re: ....... Fish Trap Tips ........
« Reply #17 on: Mar 14, 2007, 03:38 PM »
Anybody that has a new Fish Trap with the swivel seat I suggest putting some loc-tite on the screws that go into the actual chair from the long black cylindrical tubes. This will prevent seat wobble and the screws from working loose.
Some men fish real hard but only "real men" fish hardwater!

Dave C

  • IceShanty Rookie
  • **
  • Posts: 8
Re: ....... Fish Trap Tips ........
« Reply #18 on: Nov 05, 2007, 08:24 PM »
My original post from last year got lost too. I secured my tent with office binders (the medium size) rather that using screws and it worked great. I pinched off the chrome pinchers to make a cleaner install. Squeezed the pinchers back in at the end of the season and took them off. This allowed me to take the tent off and store inside away from critters in my shed. I would recommend this method as it held fine all season. No holes in the tent from screws and I think the binders actually hold better than the screws.

scavengerj

  • Team IceShanty Maniac
  • **
  • Posts: 1,567
  • Warm hands, warm feet and tight lines!
Re: ....... Fish Trap Tips ........
« Reply #19 on: Dec 05, 2007, 08:05 PM »
LoneWolf,
Thanks for the Outdoor Creations rod holder pics!!!! I added two of them to mine. They are pretty nice! I am not throwing stones so please don't take any offense to this but, you use a cover for your auger to catch any oil that may drip out. Over the course of a season of use and being stored, do you accumilate alot of oil in that bag? Just wondering how you go about cleaning it? I like the idea, I just have some reservations about it. Do you wash it in the washing machine? Doesn't that gunk up the machine any? What about the waste water being contaminated with oil??
DMS #525
AMSA #1102
OBPA
RFA #1053456E

 


Follow Iceshanty at Twitter Iceshanty Facebook Page Iceshanty Youtube Channel
Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.