The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: SM mag 2000  (Read 457 times)

Offline Tbayfisher

  • IceShanty Rookie
  • **
  • Posts: 1
SM mag 2000
« on: Dec 19, 2013, 01:04 PM »
I bought a mag 2000 off of someone as is and I got it running but when I press the throttle I get no change in RPM and the auger does not spin. Any ideas? Also online it says there should be a yellow compression relief button but I do not see this. Any help would be appreciated.

Offline DoctorPerch

  • Team IceShanty Regular
  • ***
  • Posts: 334
Re: SM mag 2000
« Reply #1 on: Dec 19, 2013, 01:15 PM »
Here is a link (hopefully) where you can dowload the operating manual for the engine you have, likely a 2 or 3 HP.  You can see where the yellow button should be.  As far as other help, call Strikemaster and they can help you troubleshoot if you do not get the answer on IS.

http://www.rapala.com/Owners-Manuals/strikemaster-customer-manuals,default,pg.html



Offline toofuss

  • Team IceShanty Maniac
  • **
  • Posts: 1,183
  • stick 'em
Re: SM mag 2000
« Reply #2 on: Dec 20, 2013, 01:10 PM »
Is this a Solo or Techumse powerhead?

I was on a bus and just happened to be sitting on a news paper. This guy came up and asked. "Are you reading that ?"
I said  yes, stood up, turned the page and sat back down.

 



Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.