Replacement blades for Mora 6'' ?

[mcdee]

Are all after market replacement blades created equal  ? Thanks

[Woodsman]

Only 3 words are important.
Made in Sweden.

[sawblade]

In the years that I have used my Mora every time I order blades they have always come in the OE. Mora blade. I just ordered two sets from fish USA one of the IS sponsors. They had the best price and shipping price.

[bassrat]

got an old 6" mora i've been using for about 20 years on early ice...found adapters (milled aluminum) to "retro-fit" lazer blades to it at a local hardware store the other day...looks like a neat idea...hope it boosts the performance!

[jackpine]

got an old 6" mora i've been using for about 20 years on early ice...found adapters (milled aluminum) to "retro-fit" lazer blades to it at a local hardware store the other day...looks like a neat idea...hope it boosts the performance!

Now that sounds interesting bassrat. Any chance you have a name for this product or a picture?

Fran 8)

[bee]

I saw an ad on ebay ice fishing for those adapters.

[jackpine]

I saw an ad on ebay ice fishing for those adapters.

Thanks bee, there are some on there right now, $25.00. I think I'll wait and see if there are any reports on these adapters.

Fran 8)

[capt.shay]

The best way to replace the blades on a Mora is to
unscrew the top knob, slide a Finbore or Nils under it
and re-tighten the knob   

[Tainterslayer]

The best way to replace the blades on a Mora is to
unscrew the top knob, slide a Finbore or Nils under it
and re-tighten the knob   

(Image removed from quote.)

And use the non offset handles? I don't think so
The best way is to drill ONE hole, then shimmy it down the hole and let her sink. Make sure you have a NILS on the way, put the nearest boat landing as your address...

[dkfry]

The Mora blades are actually really easy to sharpen if you know what your doing. I sharpen my dads for him and the blades were in not the greatest shape, the edge tends to fold over and create a bur. His is a chinesse Mora, he needed an auger and didn't want to spend a lot of money. It actually cuts very well it just takes quite a bit of effort to turn it compared to the Lazers.

[TA]

got an old 6" mora i've been using for about 20 years on early ice...found adapters (milled aluminum) to "retro-fit" lazer blades to it at a local hardware store the other day...looks like a neat idea...hope it boosts the performance!

Bassrat,

I'm curious. Hows that adapter to retro-fit the lazer blades to a mora auger working out for you?

[MarkC]

I'm curious. Hows that adapter to retro-fit the lazer blades to a mora auger working out for you?
I am also curious and went looking for the adapter on ebay but couldn't find any. I have an 8" Mora that I would like to convert to Lazer blades. Anyone know where to find the adapters?