The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: Jiffy 31 run issue  (Read 208 times)

Offline Mills

  • IceShanty Rookie
  • **
  • Posts: 2
Jiffy 31 run issue
« on: Mar 12, 2019, 01:48 PM »
Hey guys, i inherited a jiffy model31 auger a few years back. Cleaned the carb and put fresh gas and been using since. I recently went with a buddy who had a new jiffy, unsure of model, and it really screamed. Mines never really had that 2 stroke scream. Replaced spark plug, replaced carb diaphragm, tried adjusting carb screws, still runs the same. Any ideas?

Offline bowmandan

  • Team IceShanty Regular
  • ***
  • Posts: 317
Re: Jiffy 31 run issue
« Reply #1 on: Mar 12, 2019, 04:38 PM »
Run some sea foam through it.  Brobably a dirtyjet.  Some take time to come on the governor to get that 2stroke scream going

Offline Mills

  • IceShanty Rookie
  • **
  • Posts: 2
Re: Jiffy 31 run issue
« Reply #2 on: Mar 13, 2019, 11:00 AM »
Thanks, will try that. I also noticed the high speed screw has a blunt end, is this normal or do i have a broken tip? The low speend has a nice fine tip to it in comparison.

 



Follow Iceshanty at Twitter Iceshanty Facebook Page Iceshanty Youtube Channel
Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.