Please welcome Eyoyo Underwater Fishing Cameras.https://amzn.to/3siEgXn
I built an 8x11 shanty with 2x2 framing and foam sheathing. I have attempted to minimize the weight as much as possible. The base has two 2x10 runners on each side with HPDE plastic on the bottom making two 8" wide skis. This shack is at a cottage and will only be dragged down a boat ramp onto the lake and then put away in the spring. I need to build a pull system for it. I lag bolted 4 feet of angle iron 1/4 inch thick and 3.5 wide on the inside of each ski to add strength and provide pulling points. I estimate the shack is below 1500 lbs. I could just drill holes in the angle iron ends and use chains, but managing the shack down the steep boat ramp will be a pain. I was thinking of going rigid and using galvanized pipe and smashing the ends to make an a-frame, but i am not certain it will take the pull weight. Perhaps i could put a chain inside the pipe? Looking for some recommendations as I want to keep things simple and cost effective. I don't have a welder. I plan to use my side-by-side to tow once on the ice. Suggestions?