The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service
Pages: [1] |   Go Down

Author Topic: Power Auger problems  (Read 455 times)

Offline Frabill 44

  • IceShanty Rookie
  • **
  • Posts: 96
  • St.Croix alls i need!! Chicago Fire Department
Power Auger problems
« on: Jan 20, 2010, 11:06 PM »
I have an older power auger Strikemaster about 5 years old, and i just had the blades sharpened, but it cuts really slow for some reason. For about 9 inches of ice it takes a good 3 minutes to cut. Any ideas whats wrong? i see these power augers on the ice cutting through 10 inches of ice in 5 seconds lol
Logged

Offline Swift

  • Team IceShanty Maniac
  • **
  • Posts: 2,728
Re: Power Auger problems
« Reply #1 on: Jan 21, 2010, 12:57 AM »
Would lay odds they missed the angle on the sharpening. Good bet is to go down to the Equipment Forum and try again............ Seems they did it for you
Logged
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.