The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: mag 3 auget problems can anybody help  (Read 453 times)

Offline kempsguy

  • IceShanty Rookie
  • **
  • Posts: 5
mag 3 auget problems can anybody help
« on: Jan 11, 2010, 11:09 AM »
I have a old mag 3 that won't idle for more than 15 seconds and. Then quits I noticed it leaks threw the bottom of the
fuelt tank where the fuel line connects to the filter any suggestions? Thanks

Offline sawblade

  • Team IceShanty Regular
  • ***
  • Posts: 134
Re: mag 3 auget problems can anybody help
« Reply #1 on: Jan 11, 2010, 01:17 PM »
I think you have two problems. 1. the no run. The carburetor is gummed up from the fuel that gets left in the passages. You need to remove the carburetor and clean it. I use carburetor cleaner from a automotive parts store. You may need to get a kit to make it run well. 2. Go to a small engine shop or call strikemaser and get a new fuel line. You need line that has thicker wall thickness.
Hope it helps some

 



Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.