IceShanty.com's Ice Fishing Community
Ice Fishing Tips -Check your local regulations! => Ice Fishing Transportation => Topic started by: keithm87 on Oct 15, 2013, 07:07 PM
-
I just did some work for my stepfather and in return I was given his old sled. It has low miles looks just about new, but hasn't seen snow in several years. He said he started it every winter a couple times to make sure it ran, but today when we got it out of the garage and pulled the start, it came with little resistance (like only the resistance of the spring) it recoiled into the housing normal, but there was no normal resistance and engine didn't start. I have a total of 0 knowledge on engines, let alone sled engines. Any idea what might be issue? Sled is a 1997 Cat 600 EXT triple. The engine looks almost new. Hoping for an easy cheap fix!
Thanks for any help,
Keith
-
Sounds like the dogs in the recoil assembly are not engaging...probably just needs cleaning and lite lubrication.
-
I agree, there are dogs that when you pull the recoil engage onto the flywheel/stator. They are lubricated from the factory and that lube is probably dry or sticky. You should be able to pull off the whole recoil assembly and spray a little lube onto the dogs. And if you want a quick fix, you should be able to whip the recoil a few times real fast, just pull it a foot or so at a time and repeat and it might break the dogs free with centrifugal force.
-
The dogs are definitely not engaging do to lack of lubrication or corrosion. Since they work on the centrifugal force caused by the pulling of the starter rope the fact that they are not engaging is because they are not pivoting freely.
-
It is a dog problem. Did you pull the cord right off as hard as you would to start it or did you pull a few inches out until you might have felt the dogs engage?
I ask only because last winter I went to start my buddies sled and grabbed the starter handle and yanked it. The dog (starter pawl it is actually called) broke. It is only made of plastic and I guess you are supposed to pull out on the cord a little until you feel the pawl engage then give it the robust yank to start it.