IceShanty.com's Ice Fishing Community
New Hampshire => Ice Fishing New Hampshire => Topic started by: merk42 on Oct 18, 2018, 12:55 PM
-
Hey last season some one posted an alternative blade to the ION expensive replacements.. Anyone remember that thread.. I think it was Mora blades but there was something about the holes not matching or something..
-
Hey last season some one posted an alternative blade to the ION expensive replacements.. Anyone remember that thread.. I think it was Mora blades but there was something about the holes not matching or something..
If you have a mora you can use the extension and put the whole mora flute onto the ion using the extension. They are both shaver blades so I'd imagine if the mounting holes line up the blades should work. The blades on the ion are the worst part of the auger. I'm on my 5th pair on the 2nd generation Ion. If you hit any type of dirty ice you will need new blades.
-
I have not had a durability issue yet however when I went to buy a backup pair last year they were unavailable.
-
I have not had a durability issue yet however when I went to buy a backup pair last year they were unavailable.
Jason got some.from above sponsor. Put my new spare blades on last night and put newer extra spare in tackle bag for emergency. Strike now on the blades everyone has them now.
-
Jason got some.from above sponsor. Put my new spare blades on last night and put newer extra spare in tackle bag for emergency. Strike now on the blades everyone has them now.
Done!
-
good job they are hard to find mid season. I keep extra just in case. This is the 1st season I have had to change them. A word of caution the blade screws are very tight, took a while to swap out in the comfort of home hopefully wont need to swap out on the ice; it could be a challenge.
-
I have both new and sharpened 8” and new 6” spares...I’m good for a while!
-
Watch out don't over tighten them. I broke two blades last year because I over tightened them.
-
Watch out don't over tighten them. I broke two blades last year because I over tightened them.
I put a drop of blue loctite on the threads then just snug them.