The ice fishing Montana boards are sponsored by:

Pages: [1] |   Go Down

Author Topic: help with augers blades  (Read 903 times)

Offline fishingtroll

  • IceShanty Rookie
  • **
  • Posts: 11
help with augers blades
« on: Jan 18, 2007, 08:10 PM »
hey guys
  I have two Mora ice augers that when you put on new blades on the auger they dont cut the ice. it is like they are dull.Is there any suggestions that will help me?
Logged

Offline Desperado

  • Team IceShanty Maniac
  • **
  • Posts: 1,074
  • . . . . . . Happy Trails . . . .. Des .. IBOT #328
Re: help with augers blades
« Reply #1 on: Jan 18, 2007, 08:49 PM »
try changing the blade's "angle of attack" by shimming under the back side or front side
experiment a little and see if you get an angle that works
Logged
Have YOU Clamped YET ?

Offline Seedtree

  • Team IceShanty Addict
  • *
  • Posts: 663
  • The older I get, the better I was.
Re: help with augers blades
« Reply #2 on: Jan 19, 2007, 09:49 PM »
It's very easy to put them on upside down or on the wrong side of the steel mounting surface.  In either case, they won't cut ice.  Double check it and if in doubt, refer to your owners manual or the appropriate website.

Tight lines.
Logged
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.