Click here to order with free shipping.Team Iceshanty Patches! Most iceshanty boards are represented
manual says 24:1Face plate on the powerhead says 24:1Mix in the jiffy tune up kit has a oil-stabalizer. It is 94.6 ML and says to mix it with 4L of fuel, that is like 43 ish:1 ratio.so that is a little confusing to me.I am wondering if there is a websire out there that states what mixes of OIL-to-STABILIZER-to-GAS ratio?Must make a difference, OR on of either....: the owner's manual of my Jiffy 30, the oil in the tune up kit or the actual plate on the jiffy powerhead ARE WRONG...and JIFFY can't tell me which....HA HA HAGood luckl!!
That is some groovy info.I guess a guy just has to mix...fuel ...stabilizer....then decide on synthetic or conventional oil...choose a ratio;and start tunning.This will be the third year in a row, that I have tuned up the auger and experimented to try to get it to run "WELL"....I would say NOW......it is shy of running "GOOD"..Good luck....And GOOD TUNING!!
I have Amsoil Interceptor for my snowmobile I was thinking using in my Normark auger. Any of you using it instead of the Saber?
Ok, because I'm a total idiot, I need to ask to clarify.I have the Jiffy Tecumseh 3hp motor (24:1 recommended), and an echo kioritz weed trimmer (50:1 recommended)If I'm following this thread right, I could potentially use the Amsoil Saber mixed at 50:1 ratio (or even leaner) and use that fuel for both engines? Because the lubricity would be more than adequate even though the oil mix ratio is different?
Isnt it cheaper to have some smoke and foul a few plugs than blow a piston?