The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: Pistol bit with Ion  (Read 253 times)

Offline Van Noord

  • Team IceShanty Regular
  • ***
  • Posts: 247
Pistol bit with Ion
« on: Feb 28, 2021, 05:41 AM »
I heard of it happening, but haven't seen it applied...but will the composite Pistol bit flight or Ion G2 flight fit a Gen1 Ion powerhead without modification or an adapter? Thanks!

Offline hardwater diehard

  • Iceshanty Militia
  • Team IceshantyInsanity
  • *
  • Posts: 10,041
Re: Pistol bit with Ion
« Reply #1 on: Feb 28, 2021, 06:28 AM »
If you have the ION ..just measure the output shaft ..or try and put a hand auger on it for size . The Pistol Bit has a 18mm input diameter (most hand auger) Or if you have a power head(gas/propane) auger on your ION try that drill unit on it ..most powerhead drill units are 22mm .
Give a man a fish he eats for a day .Teach a man to ice fish he has an obsession for a lifetime


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996-
All Rights Reserved.