Mora Ice Ultra Light w/Power-Point

[Damn Yankee]

I added a Strikemaster Power Point to a 6" Mora Ice Ultra Light. Cuts overlapping holes real good.
Should be MANDATORY on all augers.

[Anderj85]

Do remember what thread size the power point has on it?

[SirCranksalot]

i added this furniture leg type of screw to mine and it fixed any wandering prob

[Damn Yankee]

Do remember what thread size the power point has on it?

Yes: It is 10X1.5mm (10mm diameter x 1.5mm thread pitch). What's nice is the head on the Mora unbolts and has a stem on the end. Goes into a lathe real nice for perfect on center tapping.
The only problem is you end up being able to screw the power point in too far. So I took a washer (same I.D. as the 10mm power-point thread)
did a 60˚countersink and put it on the pp.  It stops the pp from going in too far.
Also added another washer to bring the pp out to what looks like the right amount sticking out.

[pmaloney86]

I added a Strikemaster Power Point to a 6" Mora Ice Ultra Light. Cuts overlapping holes real good.
Should be MANDATORY on all augers.

You are a genius sir!  My Mora walks all over the place with the clam drill setup.  Are you taking orders?  I'm right down the road.

[kondan]

I did this mod on my mora nova too and my lazer synthetic.