Top
Proshop
Sponsors
News:
Please welcome Eyoyo Underwater Fishing Cameras.
https://amzn.to/3siEgXn
Home
Forum
Help
Login
Register
IceShanty.com's Ice Fishing Community
»
Ice Fishing Tips -Check your local regulations!
»
Equipment
»
Ice Augers
(Moderator:
Bean
) »
8"Fin Bore with small drill and Clam Gear Box?
The Iceshanty Ice Auger Board is sponsored by
Print
Pages: [
1
] |
Go Down
Author
Topic: 8"Fin Bore with small drill and Clam Gear Box? (Read 741 times)
fundseeker
IceShanty Rookie
Posts: 17
8"Fin Bore with small drill and Clam Gear Box?
«
on:
Dec 30, 2017, 12:09 PM »
Has anyone turned an 8" Fin Bore with the Clam Conversion Kit Gear Box on the Clam Drill Plate with a smaller drill? I am wondering if my CTC Maximum 20 volt Lithium Ion drill putting out 500 inch lb will turn an 8" with the new gear reduction box now available . It will turn my old 6" F.B. for many holes in 2-3-ft of ice no problem but barely turns the 8" F.B. I just bought . The anti overtorque shut off built into the batteries shuts it down every 5 sec or so. The gear reduction box would be a lot cheaper than buying a new M18 Milwaukee with 1200 in lb torque.
Logged
buz23
Team IceShanty Addict
Posts: 932
Re: 8"Fin Bore with small drill and Clam Gear Box?
«
Reply #1 on:
Jan 02, 2018, 04:49 AM »
Is the drill brushless? What is the battery rating? If you buy the geared clam plate you might find it does work but you only get a few holes. And if it is not brushless, it probably will fail even with the gear plate.
Logged
Print
Pages: [
1
] |
Go Up
IceShanty.com's Ice Fishing Community
»
Ice Fishing Tips -Check your local regulations!
»
Equipment
»
Ice Augers
(Moderator:
Bean
) »
8"Fin Bore with small drill and Clam Gear Box?
Iceshanty
|
MyFishFinder
|
MyHuntingForum
Contact
|
Disclaimer
|
Privacypolicy
|
Sponsor
© 1996- Iceshanty.com
All Rights Reserved.