Pages: [1] |   Go Down

Author Topic: ATV Seat  (Read 978 times)

Offline NORRM

  • Team IceShanty Regular
  • ***
  • Posts: 226
  • I see fish lurking about the chilly depths!!
ATV Seat
« on: Jan 16, 2014, 12:01 PM »
Has anyone had a problem with the staples holding the seat skin on rusting to the point that the skin starts come undone. I tried using a battery powered stapler with 1/4 inch 6mm staples and they just bend over doing nothing. it's like the plastic is to tough to penetrate. Any ideas?
Logged
Give a man a fish and he eats for a day
Teach a man to fish and he'll sit in his shanty all day and drink BEER!!

Offline JonPerry

  • Team IceShanty Addict
  • *
  • Posts: 721
Re: ATV Seat
« Reply #1 on: Jan 16, 2014, 12:35 PM »
air stapler, or take it to an upholstery joint ;)
Logged

Offline indeeptreble

  • Team IceShanty Regular
  • ***
  • Posts: 380
  • Every hour you fish adds an hour to your life!
Re: ATV Seat
« Reply #2 on: Jan 18, 2014, 09:17 PM »
I did my own seat recovering and used a hand staple gun bostick old all metal had to use the edge of the table being the seat edge if I turned the seat over just on the foam it wouldn't drive the staple all the way in. I also had to use a hammer and finish driving some other stapes in. Since then i bought myself a upholstery air stapler foe next time was 35 bucks here in Canadian tire. 
Logged
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.