(Updated with Picture) Throttle linkage for a Jiffy Model 76

[Ice-D]

Anyone had any luck finding the plastic slide where the throttle linkage connects to the motor.  Jiffy's parts breakout stops at the linkage wire and I can't find it on the diagrams on Tecumseh's website.  Any help with a source or even a parts number would be great.



The small U-shaped piece of gray plastic in the red square. 

Thanks

[Roccus]

your discription is vague... but look at P/n 200...is that what you are looking for? http://www.partstree.com/parts/?lc=tecumseh&mn=TM049XA-3602B&dn=ETM049TM049XA3602B-EN

[Ice-D]

your discription is vague... but look at P/n 200...is that what you are looking for? http://www.partstree.com/parts/?lc=tecumseh&mn=TM049XA-3602B&dn=ETM049TM049XA3602B-EN

Thanks, but that doesn't look like the right linkage. 

I've updated the original post with a picture.  It's a U-shaped piece of plastic that hooks to the throttle lever on one end and a spring and the throttle butterfly on the other.  It looked pretty cheesy, so I figured it was probably a common failure.