IceShanty.com's Ice Fishing Community
Ice Fishing Tips -Check your local regulations! => Equipment => Ice Augers => Topic started by: TIBS on Nov 20, 2018, 10:33 AM
-
(https://i.imgur.com/jr7Jqv9.jpg)
I put this plate on my Kdrill, because I don’t trust the float, and I’d rather not have it sink below the ice. 1/8” Aluminum cut to 8-3/8” OD with a 7/8” ID hole for the spindle, with 2 #12x3/4 SST self drilling sheet metal screws.
-
I think that’s a better insurance. I’ve always wondered if the ice isn’t too thick, if it fell out and sank a bit before bobbing up, couldn’t it slide under the ice and not always straight back up the hole? Plus if there’s any current there it goes anyway.
-
Modified Strikemaster plate for Kdrill
(https://i.postimg.cc/G4nbYhF3/Snapchat-70603867.jpg) (https://postimg.cc/G4nbYhF3)