The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service
Pages: [1] |   Go Down

Author Topic: ridgid 700 lb torque drill for nils 6 ''  (Read 740 times)

Offline ougot1

  • Team IceShanty Regular
  • ***
  • Posts: 154
ridgid 700 lb torque drill for nils 6 ''
« on: Jan 03, 2019, 09:49 AM »
I am trying to figure  out if a ridgid 700 lb torque drill is a good match - choice for a 6 '' nils auger ? if anyone has this setup how do you like it ? the batteries are 4ah , so it should drill some holes . any replies appreciated .    THANKS
Logged

Offline 3300

  • Team IceShantyholic
  • ***
  • Posts: 7,631
  • Michigan Moderator.Not affiliated with MarCum Tech
Re: ridgid 700 lb torque drill for nils 6 ''
« Reply #1 on: Jan 03, 2019, 10:23 AM »
you'll be fine. i used a 500 inch pound ridgid drill with 6 ich lazer for years.
Logged

Offline PikeKing23

  • Team IceShanty Addict
  • *
  • Posts: 908
  • Go Big or Go Home!
Re: ridgid 700 lb torque drill for nils 6 ''
« Reply #2 on: Jan 03, 2019, 11:06 AM »
Agreed.  I used a 556? ft/in with an 8" Mora for years.  If you have any problems, it will be because of your battery.  That is the week link in your setup.  Remember you need sharp blades, too.
Logged

Offline lefty2053

  • Team IceShantyholic
  • ***
  • Posts: 7,969
Re: ridgid 700 lb torque drill for nils 6 ''
« Reply #3 on: Jan 03, 2019, 11:42 AM »
I have 2 of those drills 700 "# and they turn my 7" Nero.
Logged
<===Lefty===
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.