hole in sled

[pa.bob]

I got a hole in corner of the sled on my clam guide. I was wondering what wud b the best patch 2 put on it? After i patch it then im boltn sum skis 2 it. Thanx for anyones advice.

[tbfisherman]

Plenty Of Duct Tape if the hole isn't too Big.....Seriously

Bob

[hunter orange]

yea "duck tape" lol that aint red neck haha try pop rivets and aluminum 

[DEADONDYLAN]

depends on size? A plastic welder(soldering iron) can be had at harbor freight for 20$. Not as flexable as original material but does not break loose again as some fixes might. Just heat the mesh into existing plastic and fill with plastic sticks provided. let the iron do the work don't push as tips are very susceptible to breakage if used with force(been there done that) no replacement tips are available that I can find.

[Wiener]

I would make a form and buy some of the truck bed lining paint.  I think it's called Rhino Lining.

It goes on about a 1/4 inch thick.
When it dries, it should be good as new.

Hope this helps,

Wiener