The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: linkage help  (Read 461 times)

Offline Tim B

  • Team IceShanty Regular
  • ***
  • Posts: 126
linkage help
« on: Feb 14, 2013, 10:17 AM »
hey guys i have an older eskimo 8600 which i took apart to reaint and give it a face lift. well i forgot how the linkage goes from the carburetor to the black plastic piece under the pull start housing and i was wondering if someone who might have one of these could post a picture of how the linkage is set up. thank you

Offline Tim B

  • Team IceShanty Regular
  • ***
  • Posts: 126
Re: linkage help
« Reply #1 on: Feb 14, 2013, 11:17 AM »
i just need a picture looking down from the top without the starter housing on to see ow the linkage hooks up to the carburetor.one i see that i'll be good to go. thank you

Offline Tim B

  • Team IceShanty Regular
  • ***
  • Posts: 126
Re: linkage help
« Reply #2 on: Feb 14, 2013, 01:49 PM »
i found a diagram that shows what i needed to know. thanks

 



Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.