I live in the state of Wyoming and I catch a lot of splake on customized Jigging Rapalas. I repaint a size 7 with glow in the dark jig paint (it has a much better glow than Rapalas factory glow paint jobs). I then replace the factory treble (too small) with a couple sizes larger Owner or Gamakatsu treble and hang it slightly lower with a piece of wire. Tip it with a minnow head and jig it very aggressively for several strokes (I use a 7 foot medium light rod with 6lb test). Pause it, make a few shorter strokes, pause and make larger aggressive strokes. Cover the water column from about 8 feet down to about a foot off the bottom. Hits are usually on the fall or just after you stop to pause. If you are allowed to use more than one rod set up a deadstick with a small glow in the dark jig like a Northland Gypsi tipped with a small live (if legal or dead if not legal) minnow set around a foot to two feet off the bottom. I use a much shorter rod and walk over and pull the line up in the water column frequently. Splake often hit this rig very light so a spring bobber or other lite detection device is required. Hits often happen right after moving the rig and letting it sit again. I've had a lot of splake follow the deadstick up and hit close to the bottom of my ice hole. Also if you miss a fish, they will often hit again if they haven't stolen the bait so keep doing whatever you were doing. If action stops, check your lure as it was likely debaited. If you locate fish at a certain level move both setups to that depth as splake are a schooling fish. Good luck.