The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: Kdrill plate installed  (Read 976 times)

Offline TIBS

  • Team IceShanty Addict
  • *
  • Posts: 798
  • Tipup!!!!!
Kdrill plate installed
« on: Nov 20, 2018, 10:33 AM »


I put this plate on my Kdrill, because I don’t trust the float, and I’d rather not have it sink below the ice.  1/8” Aluminum cut to 8-3/8” OD with a 7/8” ID hole for the spindle, with 2 #12x3/4 SST self drilling sheet metal screws.

Offline Seamonkey84

  • Team IceShanty Maniac
  • **
  • Posts: 2,469
Re: Kdrill plate installed
« Reply #1 on: Nov 20, 2018, 10:47 AM »
I think that’s a better insurance. I’ve always wondered if the ice isn’t too thick, if it fell out and sank a bit before bobbing up, couldn’t it slide under the ice and not always straight back up the hole? Plus if there’s any current there it goes anyway.

Offline SpoonieLuv

  • Team IceShanty Regular
  • ***
  • Posts: 463
Re: Kdrill plate installed
« Reply #2 on: Nov 22, 2018, 11:18 AM »
Modified Strikemaster plate for Kdrill


 



Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.