IceShanty.com's Ice Fishing Community
Ice Fishing Tips -Check your local regulations! => Equipment => Ice Augers => Topic started by: DANMAN on Feb 09, 2021, 09:21 PM
-
Especially powered augers
Tilt your auger 5 to 10 degrees off vertical when drilling. helps avoid blades getting bound at break thru
The rationale being ...... that a tilted auger will create a downward “leading edge” and a “trailing edge” to the hole being drilled.
Break thru will occur at the leading edge. And not across the entire circle face of the hole
Seems to work well for me. IMO
-
I will give that a try. Sounds logical.
-
Definitely trying that- I hate when that happens, I'm always afraid that I'm going to damage the auger
-
I believe I may have invented this technique ;D..all may holes tend to be at a bit of an angle ...as I put my Clam Plate out in front of me ..arms length...start to drill and then step over top of it to finish the job.