The ice fishing Wisconsin boards are sponsored by:

Pages: [1] |   Go Down

Author Topic: Nils hand auger  (Read 475 times)

Offline pauld

  • IceShanty Rookie
  • **
  • Posts: 16
Nils hand auger
« on: Jan 14, 2013, 06:50 PM »
I brought a nils 8 inch hand auger. The first couple holes it worked fine. From then on it drills the first cupole of inches fine and from there on it is a pain. Can not figure out what I m doing wrong, I use both arms when drilling. Any suggestions would be greatly apprciated and thank you.

pauld
Logged

Offline boder

  • Team IceShanty Regular
  • ***
  • Posts: 473
Re: Nils hand auger
« Reply #1 on: Jan 14, 2013, 09:09 PM »
What do u mean its a pain? A little more description would b nice. I know sometimes mine will just scratch the surface up a lil if I am not drilling straight down.
Logged

Offline pauld

  • IceShanty Rookie
  • **
  • Posts: 16
Re: Nils hand auger
« Reply #2 on: Jan 14, 2013, 10:14 PM »
It just scratches the surface until I clean the hole. it will cut for a few turns then scrathes the surface till i clean hole again.

pauld
Logged

Offline paullo19

  • Team IceShanty Regular
  • ***
  • Posts: 111
Re: Nils hand auger
« Reply #3 on: Jan 15, 2013, 07:10 AM »
Sounds like the blades are at the wrong pitch/angle.Get a hold of Nils and I am sure they will help you. Paul
Logged
Pages: [1] |   Go Up
 


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996- Iceshanty.com
All Rights Reserved.