The Iceshanty Ice Auger Board is sponsored by
Nils Master Authorized Sharpening Service

Author Topic: wobble with a Clam plate  (Read 674 times)

Offline SirCranksalot

  • Team IceShanty Maniac
  • **
  • Posts: 1,598
wobble with a Clam plate
« on: Feb 21, 2023, 06:08 PM »
My Mora auger wobbles quite a bit which sometimes seem to cause the drill to stall. There is a fair amount of 'play' on the shaft of the Clam plate. I guess there is some damage or wear on the bearing or bushing of the Clam. I don't see how to fix this except maybe buying a new bearing and replacing. I don't know if I can, in fact, buy one---none I see listed on their site----and to replace might be quite a challenge. Any suggestions? TIA
Keep yer stick on the ice!

Offline hardwater diehard

  • Iceshanty Militia
  • Team IceshantyInsanity
  • *
  • Posts: 12,163
Re: wobble with a Clam plate
« Reply #1 on: Feb 21, 2023, 06:51 PM »
Give a man a fish he eats for a day .Teach a man to ice fish he has an obsession for a lifetime


Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Privacypolicy | Sponsor
© 1996-
All Rights Reserved.