Author Topic: Vexilar sitex fl-8 connector pin out (Read 1226 times)

DANMAN · « **on:** Jan 18, 2015, 07:15 PM »

Can anyone tell me which transducer wires solder to which connector pins?

I bought a third party transducer I wish to try

Thanks

Danman

Old Goat · « **Reply #1 on:** Jan 18, 2015, 07:26 PM »

I'm only seeing 2 wires

DANMAN · « **Reply #2 on:** Jan 19, 2015, 09:48 PM »

Which pin does black solder to? Red?

Old Goat · « **Reply #3 on:** Jan 19, 2015, 09:56 PM »

I'm looking at a grey wire and one wire with no covering. Is you sitex a 3 hole set up

DANMAN · « **Reply #4 on:** Jan 20, 2015, 12:08 PM »

yep sitex 3 hole. if you look close you can see the numbers

walkndude · « **Reply #5 on:** Jan 20, 2015, 01:39 PM »

The transducer wiring is in the manual which is available on si-tex's website. Figure 8 on page 8(page 11 of the pdf).

Old Goat · « **Reply #6 on:** Jul 13, 2015, 01:58 PM »

white 3 shield 2 black 1 is that what your seeing walkndude?

News: